Helpful Tips
Expert Advice for Your Products
Maintenance of protection
Detection of scratches or areas of asphalt exposure - on the surface - by external mechanical action...
Membrane fixation and adhesion test
Note that poor adhesion is likely to reduce tolerance to high impact, punching or other undesired me...
Condition and conservation of the load wall throughout the perimeter of the waterproofing
Remember that any fissure in the loading wall - outside the waterproofing area - even on its side pr...
Maintenance
Proper maintenance of a membrane contributes to the durability and performance of the waterproofing ...
Weather conditions
Waterproofing work should not be carried out when climatic conditions could be harmful or there is a...
Evaluation of the surface
It must be checked whether the roof surface fulfills the necessary conditions for the execution of a...
Storage
These products must be conditioned in fresh and dry places, protected from rain and sunlight, as wel...
Non-ferrous metals (aluminum and zinc)
To apply acrylic enamel Magister the only condition that must meet the surface is to be clean and dr...
Woods
In new or exposed woods (untreated): sand in the direction of the grain until a smooth surface is ob...
Ferrous metals (steel or iron)
On new or exposed metal surfaces: If you are going to use 3 in 1 Converter or Enamel, they can be ap...
Masonry, concrete, plaster and cementitious plasters
On new surfaces; keep in mind that the new walls have high alkalinity due to the chemical prope...
General considerations
Make sure the surface is perfectly prepared for the product to be applied.
